Battery Dimmer
Pairing your Battery Dimmer:
Installation note: To make sure that your Battery Dimmer is installed correctly remove the faceplate and check the arrow is pointing upwards.
Pairing Mode:
To put the Device into pairing mode hold the rotary knob for 6 seconds. When the Dimmer has entered pairing mode the red LED will flash continuously. The red LED will remain fully on for 4 seconds to signify it has successfully paired to your Hub.
Battery Remote
Pairing your Battery Remote:
Step 1: Remove the battery cover from the back of the Remote and insert the battery.
Step 2: Press and hold the pairing buttons besides the battery for 3 seconds and then release.
Step 3: A periodic flash will confirm the Remote is searching for a Hub. A constant red light indicates the Remote is successfully paired.
Kinetic
Pairing your Switch:
Step 1: Press and hold the bottom left button for 10 seconds, then release.
Step 2: Press and immediately release the bottom left button once.
Step 3: Press and hold the bottom left button for 10 seconds, then release.
Step 4: Press and release (number stated on the App screen) times.
Stop pressing!
Top store the channel, simply press one of the other 3 buttons on the switch.
Rotary Dimmer
Pairing your Rotary Dimmer:
Press and hold down the rotary dimmer for approximately 10 seconds. The LED ring around the dimmer will begin flashing repeatedly.
If you need any further help or have any questions, please email us at aone.help@auroralighting.com, raise a support ticket, using the link near the bottom of this page or clicking on the HELP button (a blue circle with a question mark) or call us on:
UK: +44 (0) 1707351859
Phone lines are open Mon-Fri 9am-5pm.